contact us

contact-email
contact-logo

Guangzhou Xinghe Aluminum Composite Panel Co., Ltd.

We provide customers with quality products and provide high-quality services

看不清,请点击我!

If you would like to leave us a comment please go to contact us

contact-clo

What is Aluminum Composite Panel Production Process

  • source:Xinghe
  • Date:12/25/2018

There are many production processes for aluminum composite plate. According to the composite process of plastic core panels and two-sided aluminum panels, it can be divided into the cold composite method and thermal composite method; it can also be divided into the continuous composite method and intermittent composite method.

red aluminum composite panel


The process for producing aluminum-plastic panels is first to clean the aluminum coil. In the production of aluminum coils, due to the needs of the process, the surface is coated with lubricants and anti-oxidants, and some dirt will be attached during transportation, which will affect its adhesion and must be cleaned. After cleaning and chemical treatment, the aluminum coil will have a dense chemical protective film on the surface; this chemical film can improve the oxidation resistance of the aluminum coil and prolong the life of the film. The general process of cleaning is as follows: aluminum coil→spray degreasing→water washing→neutralization→chemical treatment→water washing→drying→cooling→winding.

 

The cleaned aluminum coil is fed to a coater and coated with a high-performance fluorocarbon resin on the outer surface of the aluminum coil. The process flow is as follows:

 

Aluminum coil→feeding→coating fluorocarbon coating→hot air circulation baking paint→cooling→filming→cutting→winding.

 

The panels of the exterior aluminum plastic composite panel are coated with two layers of paint and primer. The topcoat of the façade is a highly weather-resistant fluorocarbon resin coating, namely polyvinylidene fluoride (PVDF). Its excellent UV resistance and environmental pollution keep the surface of the protected aluminum coil beautiful. The surface of the aluminum-plastic composite panel can have not only the color of the metal but also the beautiful marble pattern and color. Fluorocarbon coatings are usually applied to aluminum coils by roll coating and then baked at elevated temperatures to dry them. The equipment is continuously produced, first primed, then topcoated, and finally coated with a surface varnish. The total thickness of the three-layer paint is up to 30μm. Each layer of paint needs to be baked at 200 °C for about 60s to make it dry. After the oven is baked, it is quickly cooled by an air cooler. The interior wall paint can be made of epoxy resin, polyester resin, and acrylic resin. After the primer, topcoat, and surface varnish are coated, immediately apply a PE protective film on the surface of the coating to avoid scratching the surface coating during subsequent processing, transportation, and installation.

 

The protective film is self-adhesive and can be removed after installation. The aluminum coil coated with fluorocarbon resin can enter the process of compounding with the plastic core material. The plastic core material is also essentially three layers, with PE plastic in the middle and adhesive on both sides. PE sheets and adhesives can be produced separately or by three-layer coextrusion. Firstly, the three-layer co-extruded sheet with the structure of adhesive/PE/adhesive is produced and then combined with the upper and lower aluminum sheets. The composite aluminum-plastic composite board has 0, 15 mm thick aluminum plates on both sides, and the core layer is 3. ~ 5mm, the total thickness is 4 ~ 6mm. Finally cut into 1220mm × 2440mm specifications.

top